As for specific brands, I think any quality product will work just fine. In other words, you want a skimmer rated for about a 250 to 300 gal tank. Generally you want a skimmer rated for a tank about double the size you plan to run it on. Skimmer manufacturers tend to be "very optimistic" when it comes to rating their products. The skimmer your looking it is a good skimmer, but it's too small for your application, as it's rated for a 150 gal tank. You'll get noise from other parts of the system. ![]() Remember that your only testing overflow noise here. ![]() If it's completely intolerable then do the conversion to the bean animal overflow. Fill the tank with FW and start things up see how the overflow noise compared to the noise from everything else in the room. Plumb the overflows to the return, and plumb you return pump. You can use any old tank like a 15 gal or 20 long as a test sump. I recommend doing a test on the overflow system. What I might think is minimal noise might sound like a freight train coming through to you. As you point out you would need to cut out the existing overflows in a reef ready tank to install it. The bean animal overflow is noted for being silent, but it is a somewhat complex construction project and does involve drilling the tank. If your going to install the skimmer in the sump, make sure you can remove the skimmer for cleaning and maintenance. Since this will be a DIY project, expect to build it, find something not quite right, and then rebuild the sump. Figure about 30 gal when in operation, and it may be even less. That 55 gal tank used as a sump will end up holding a lot less than 55 gal. Many people make this section far too small. ![]() Make sure the return section is large enough to hold all the water that will drain down when the power goes off, and that the area will not run dry. Offhand, I'd say this will be a tight fit. You just never know when you might have to remove it to repair or replace it. If you are going to use a 55 gal tank as the sump, make sure you can easily get it inside the stand, with the display tank on the stand, and the stand in it's permanent location. Here are my thought on your proposed system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |